Neovibe Sound Samples

All samples used a Fender Strat made of various Fender parts & a Fender Princeton Reverb amp miked with a SM57 into a Korg D1600 recorder. No EQ, additional effects or post-processing other than fades & limiting to even out volume differences. See photos at bottom of page for pedal & amp settings.

Medium speed with intensity turned up full Neovibe into Fulltone Fulldrive 2. Guitar volume turned down a bit. 

Medium speed with intensity turned down a bit Neovibe into Fulltone Fulldrive 2. Guitar volume turned down a bit.

Neovibe into Marshall Shredmaster Guitar volume turned down a bit. Same Neovibe settings as previous clip.

Neovibe into Marshall Shedmaster with Fuzz Guitar volume turned down a bit, & turned up full around 0:24. Fuzz comes in around 0:43. Signal path is DIY Fuzz into Neovibe, & then into Shredmaster. Same Neovibe settings as previous clip.

Neovibe into Marshall Shredmaster with Fuzz This one starts with the fuzz on, & switched off around  0:39. Same set up & Neovibe settings as previous clip, but slowing down the speed towards the end.

Low intensity fast to slow Neovibe intensity turned down a third, with speed starting out 3/4, & then slowing down. Neovibe into DIY Screamer in LED clipping mode. Guitar volume turned down a bit. 

Ramp Neovibe intensity turned down a third, with speed starting out full, & then slowing down & speeding up. Neovibe into DIY Screamer in LED clipping mode. Guitar volume turned down a bit. 

Slow to Fast Neovibe intensity cranked starting with minimum speed & increasing to maximum speed.  Neovibe into DIY Screamer in LED clipping mode.